Complex 3 pin fan wiring diagram - Forgot to say that i swapped out my ubis thirteen for an ubis 13s once i thought the trouble became with the extruder. Your technote says this is most effective for the older extruder. What is the fan configuration imagined to be with the 13s?. As for the second fan i do not get the m106/107 commands inside the pronterface ui turning the fan 1 on or off so i am uncertain if adding fan 2 using your dual fan cable adapter in order that both enthusiasts are the use of the fan connector on my f5 board goes to paintings.
After installing and wiring your new printrboard (click here for wiring diagrams), you can discover which you are left with a couple of extra connections for the three-pin fan to your printrbot play with ubis thirteen warm give up. In the end, there are many feasible approaches you could energy a fan on the play.? if you have an f6 there are fan ports - one for print cooling and one for hotend cooling.? in that case, you could plug each fan immediately into it is suitable port.
2. Flow the recently removed pink twine of to the middle pin of the molex connector this is housing the ground to your three-pin fan twine. ?(the ground on your three-pin fan cord was connected to the icsp headers to your original printrboard. ?click here for picture.). *observe: after this wiring, the top fan will not begin going for walks as soon as you strength at the system. ?after set up, you'll have to problem guide instructions to power on/off the fan (m106 & m107).
Thanks - the black floor twine for the higher warm end fan became the culprit. Unplugging and replugging the molex 6 pin connector ought to have jostled the crimping in order that it was shorting in opposition to the reset pin as opposed to simply touching the ground pin. Ugh!. The trouble with the play now not connecting via usb is usually because that black cord linked to the icsp pins isn't always plugged into the correct row of pins.? circulate the connector to the opposite row and it should work well.?.